|
Hello (Hola)
The LapLink for the Sharp PC 3000 is buildt into
the computer itself, and must be downloaded from it.
Here is the what the manual says:
What is LapLink LapLink
is a communications program,
a utility which lets you exchange files with another computer. Use it, for
example, to transfer documents you've prepared at home to a desktop computer in
your office. Setting Up Before
you can begin transferring files to or from another computer,, you must connect
your computer (referred to as the local
computer by LapLink) to the computer that will send or receive files
(referred to as the remote computer
by LapLink) using the optional Serial conversion cable (CE‑302CB) and
LapLink cable (CE‑303CB), as described below. (For details on each cable, see
Chapter 14) Prepare
the two computers for LapLink communications as follows: Connect
the 10‑pin male connector end of the serial conversion cable to the serial port
on the left panel of your computer. Connect
the single 9‑pin female connector end of the LapLink cable to the serial
conversion cable. Connect
either the 9‑pin or 25‑pin connector on the other end of the cable to the 9‑pin
or 25‑pin serial port of the remote computer. 0
Turn
on both computers. 0
To
use LapLink on the remote computer for the first time, the
MS~DOS
MODE command must be available. To check, type MODE
and
press
Enter at the MS‑DOS prompt on
the remote computer. If Bad
c omma n d o r f i 1 e n ame is
displayed, the MODE command is not
available: find the MODE.COM file and either move to the
directory
that contains it,, or move the file to a directory on the DOS search
path.
If you get any other message, the MODE command is
available. 0
At
the MS‑DOS prompt on your computer, type LAP
LINK and
press Enter. You will see the
LapLink screen with the following message: Press
[F10] to install LAPLINK on remote system. Press
F10. * The screen will change and prompt you to connect the computers with the supplied cable and enter the number of the serial port you are using on the remote computer. Since you have already connected the cable, simply enter the port number, 1.
The
screen then prompts you to enter two lines on the remote computer. If you have
connected to serial port 1 on the remote computer,, enter the following two
lines at the remote computer., pressing
Enter at the end of each line: MODE
COM1:2400,N, 8, 1, P CTTY COM1 If
you have connected to port 2, substitute COM2: for COM1: in the above two
lines. After
you enter the second line, the remote computer will appear to lock up: this is
normal. Back
at your computer, press any key except Esc. LapLink Will
copy
itself to the remote computer, and display its progress. When copying has
finished, the LapLink main screen will appear on both the local and remote
computers, indicating that both computers are ready for you to use
LapLink. The
LapLink utility is bidirectional; you can use either computer to control the
other. The controlling computer becomes the local computer and the controlled
computer becomes the remote computer.
|
_______________________________________________ Sharp-pc3k mailing list Sharp-pc3k@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx http://kogs.informatik.uni-hamburg.de/mailman/listinfo/sharp-pc3k