Re: [Sharp-pc3k] Where encounter laplink.exe at the moment

[Mark Gardiner <100550.3170@xxxxxxxxxxxxxx>]

All this talk of Laplink brings back bad memories and frustrations.

My solution was to get a a copy of DOS 6.22 and hive off the Inntrlink and
Intrserv executables as these run independent anyway.

As long as you have a working parallel or serial cable they will provide a
link. Setup is as:

                  DOS 6.22 INTERLINK/INTERSVR on PC3K
                   ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

        Add the following line to the config.sys on
        both the PC-3k and your desktop PC:

        device=n:\interlnk.exe /drives=7 /noprinter /lpt
           
(if you're using parallel cables)

        device=n:\interlnk.exe /drives=7 /noprinter /com1
           
(if you're using serial cables)

        (The /com1 and /lpt switches can be ommitted if probs 
        with loading)   

        My connect success is mostly with Laplink+modem cables to 
        serial port.

        After the boot, type 'intersvr' on the PC-3k and then 
        'interlnk' on the PC, and away you go, the PC3k's 
        PCMCIA cards are available as additional drives on the 
        PC.

        Can only access both drives from the *desktop* PC if it 
        is running W9x and 32bit FAT formatted.


Mark

see my PC3K webpage...
http://home.freeuk.com/hieroglyph.index.htm



+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++++++++++++++++++++++++++++++++++++++++++++++++

_______________________________________________
Sharp-pc3k mailing list
Sharp-pc3k@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
http://kogs.informatik.uni-hamburg.de/mailman/listinfo/sharp-pc3k